Air Heater
Mostrando 1-8 de 8 artigos, teses e dissertações.
-
1. A Review of Using Conductive Composite Materials in Solving Lightening Strike and Ice Accumulation Problems in Aviation
ABSTRACT: There are many problems facing aircraft in the air during flight, such as lightning strikes and ice accumulation on aircraft surfaces. These problems usually reduce aircraft efficiency and lead to serious accidents and fatalities. However, the current protection systems used to solve these problems of aircraft represent excessive energy usage, a ha
J. Aerosp. Technol. Manag.. Publicado em: 28/03/2019
-
2. Conjugate Cooling of a Discrete Heater in Laminar Channel Flow
Electronic components are usually assembled on printed circuit boards cooled by forced airflow. When the spacing between the boards is small, there is no room to employ a heat sink on critical components. Under these conditions, the components’ thermal control may depend on the conductive path from the heater to the board in addition to the direct convecti
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2011-09
-
3. CFD analysis of tube-fin 'no-frost' evaporators
The purpose of this paper is to assess some aspects of the design of evaporators for household refrigeration appliances using Computational Fluid Dynamics (CFD). The evaporators under study are tube-fin 'no-frost' heat exchangers with forced convection on the air-side and a staggered tube configuration. The calculation methodology was verified against experi
Journal of the Brazilian Society of Mechanical Sciences and Engineering. Publicado em: 2010-12
-
4. Experimental investigation of thermal conductivity coefficient and heat exchange between fluidized bed and inclined exchange surface
The paper presents experimental research of thermal conductivity coefficients of the siliceous sand bed fluidized by air and an experimental investigation of the particle size influence on the heat transfer coefficient between fluidized bed and inclined exchange surfaces. The measurements were performed for the specific fluidization velocity and sand particl
Brazilian Journal of Chemical Engineering. Publicado em: 2009-06
-
5. Avaliação numérica e experimental de técnicas de controle para conforto térmico em edificações
Abstract: This work addresses the problem of numerical and experimental analysis of comfort control algorithms for air conditioning systems with one manipulated variable. This is a frequent case present in HVAC (Heating, Ventilating and Air Conditioning) systems. The aim of HVAC equipment is to promote thermal comfort for building occupants. So, in order to
Publicado em: 2008
-
6. Análise de imagens na avaliação do comportamento, do bem-estar e do desempenho de pintos de corte submetidos a diferentes sistemas de aquecimento / Images analysis in the behavior evaluation, welfare and performance of the young chicken submitted to different heating systems
Currently Brazil is the country that owns the biggest number of relative information to the thermal requirement of opened buildings in summer conditions of tropical climates. However, exists the need of investigations concerning the energy expense, efficiency of the heating systems, animal welfare and contamination levels of the air for the architectural and
Publicado em: 2007
-
7. Aquatubular boilers fueled by bagasse : study of energy recovery system / Caldeiras aquatubulares de bagaço : estudo do sistema de recuperação de energia
SOSA ARNAO, Juan Harold, Caldeiras Aquatubulares de Bagaço - Estudo do Sistema de Recuperação de Energia, Campinas, Faculdade de Engenharia Mecânica, Universidade Estadual de Campinas, 2008. 224p. O objetivo deste trabalho foi avaliar o desempenho termodinâmico da caldeira de bagaço e reduzir o custo do seu sistema de recuperação de energia dos gases
Publicado em: 2007
-
8. Desenvolvimento e avaliação de uma bomba de calor usada no condicionamento de ar para secagem de alimentos
A heat pump made up of a reciprocating compressor driven by a 1.1 kW electric motor, an air condenser, a dry expansion evaporator, filled with R22 refrigerant fluid and fully instrumented was circuited to a tray dryer. Ambient air was sucked through the evaporator, flowed outside the condenser and was blown into the dryer. The thermodynamic performance of th
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 31/05/1993