Improving adhesion between luting cement and zirconia-based ceramic with an alternative surface treatment
AUTOR(ES)
MARTINS, Aurealice Rosa Maria, GOTTI, Valéria Bisinoto, SHIMANO, Marcos Massao, BORGES, Gilberto Antônio, GONÇALVES, Luciano de Souza
FONTE
Braz. oral res.
DATA DE PUBLICAÇÃO
31/03/2015
RESUMO
This study evaluated the influence of an alternative surface treatment on the microshear bond strength (μsbs) of zirconia-based ceramic. Thirty-five zirconia disks were assigned to five groups according to the following treatments: Control (CO), glass and silane were not applied to the zirconia surface; G1, air blasted with 100μm glass beads + glaze + silane; G2, a gel containing 15% (by weight) glass beads applied to the ceramic surface + glaze + silane; G3, a gel containing 25% (by weight) glass beads applied to the ceramic surface + glaze + silane; and G4, a gel containing 50% (by weight) glass beads applied to the ceramic surface + glaze + silane. The specimens were built up using RelyX ARC®, according to the manufacturer’s recommendations, and inserted in an elastomeric mold with an inner diameter of 0.8 mm. The μsbs test was performed using a testing machine at a crosshead speed of 0.5 mm/min. ANOVA and Tukey’s test (p < 0.05) were applied to the bond strength values (in MPa). CO (15.6 ± 4.1) showed the lowest μsbs value. There were no statistical differences between the G1 (24.9 ± 7.4), G2 (24.9 ± 2.3), G3 (35.0 ± 10.3) and G4 (35.3 ± 6.0) experimental groups. Those groups submitted to surface treatments with higher concentrations of glass showed a lower frequency of adhesive failures. In conclusion, the glass application improved the interaction between the ceramic and the luting cement.
Documentos Relacionados
- In vitro evaluation of the retention of zirconia-based ceramic posts luted with glass ionomer and resin cements
- Evaluation of the adaptation of zirconia-based fixed partial dentures using micro-CT technology
- Bond strength of three luting agents to zirconia ceramic - influence of surface treatment and thermocycling
- Heat Treatment of Pre-hydrolyzed Silane Increases Adhesion of Phosphate Monomer-based Resin Cement to Glass Ceramic
- Luting glass ceramic restorations using a self-adhesive resin cement under different dentin conditions