The Influence of Sample Preparation on the Quantitative Analysis of the Volume Fraction of Martensite Formed in a 304l Trip Steel

AUTOR(ES)

Alves, Juciane Maria, Brandao, Luiz Paulo, Paula, Andersan dos Santos

FONTE

Mat. Res.

DATA DE PUBLICAÇÃO

23/10/2015

RESUMO

The metastable 304L austenitic stainless steels are susceptible to phase transformation induced by plastic deformation. The traditional metallographic preparation, via mechanical methods, introduces superficial plastic deformation from grinding and polishing. It is important to evaluate this effect on the results of quantitative analysis of martensite formed in 304L steels and similar alloys. In this work, phase transformation was induced by a tensile test at room temperature with two different plastic deformation rates in order to provide distinct structural conditions for the proposed analysis. X-ray Diffraction (XRD) and Ferritescopy were used to determine the volume fraction of martensite in samples with and without metallographic preparation. The results show that the analyses quantitative were not affected by metallographic preparation.

Documentos Relacionados

• Effect of rare earth oxide additions on oxidation behavior of AISI 304L stainless steel
• Effects of the rolling temperature on the formation and on the reversion of strain induced martensite in a AISI 304L stainless steel.
• Determination of phases and residual stresses after martensitic transformation induced by rolling in 304L stainless steel
• Artrodese tibiotársica com utilização de parafusos de aço inoxidável 304L auto-atarraxantes: Estudo experimental em cães
• Corrosion behavior of mild steel and SS 304L in presence of dissolved nickel under aerated and deaerated conditions