Modal Parameters
Mostrando 1-12 de 74 artigos, teses e dissertações.
-
1. Damage localization and quantification of tower structures based on the super-element method
Abstract Tower structures are sensitive to hurricanes or earthquakes, whereupon they are easily damaged due to large deflection and dynamic responses. Herein, a method is proposed to accurately identify the location and extent of damage in tower structures. Firstly, a tower structure is divided into several sections along its height, and each section is rega
REM, Int. Eng. J.. Publicado em: 2021-01
-
2. Evaluation of low-cost MEMS accelerometers for SHM: frequency and damping identification of civil structures
Abstract Sensing techniques based on accelerometers for modal parameters identification are among the most studied and applied in Structural Health Monitoring of civil structures. The advent of low-cost MEMS accelerometers and open-source electronic platforms, such as Arduino, have facilitated the design of low-cost systems suitable for modal identification,
Lat. Am. j. solids struct.. Publicado em: 12/08/2019
-
3. Stability Characteristics of a Model Trim Adjustment System for Open Loop Active Control of Thermoacoustic Instability
ABSTRACT Thermoacoustic instability in liquid rocket engines can have potentially catastrophic consequences. Active control based on feedback promises improved stability margin over a wider range of operating conditions than passive control. In the present work, the thermoacoustic characteristics of a trim adjustment active control system based on variable v
J. Aerosp. Technol. Manag.. Publicado em: 14/01/2019
-
4. Analysis of sensor placement in beams for crack identification
Abstract A previous study has shown that the mode shapes of a beam are more sensitive to damage than other vibrational parameters, thus making them better suited for crack identification purposes. However, they have the disadvantage of being more difficult to be measured. To overcome this difficulty, an interesting idea is to monitor changes produced by crac
Lat. Am. j. solids struct.. Publicado em: 29/10/2018
-
5. The dispersion curve applied in guided wave propagation in prismatic rods.
Abstract The early detection of failures in structures is a subject of great interest in engineering; several of these techniques are linked with the elastic wave propagation, using guided waves is one of these alternatives. Several structures of interest in engineering are laminar arrangements; the wave propagation in this type of structures depends not on
Lat. Am. j. solids struct.. Publicado em: 02/07/2018
-
6. Wave propagation in cellular locally resonant metamaterials
Abstract Locally resonant acoustic metamaterials have recently attracted a great interest due to their dynamic behaviour, characterized by a band gap at relatively low frequencies. This paper provides a numerical study, by means of finite element modal analyses, of the dynamic properties of 1D mass-in-mass and 2D cellular locally resonant metamaterials. The
Lat. Am. j. solids struct.. Publicado em: 04/06/2018
-
7. Modal Parameter Extraction of a Huge Four Stage Centrifugal Compressor Using Operational Modal Analysis Method
Abstract In recent years, modal analysis has become one of the essential methods for modification and optimization of dynamic characteristics of engineering structures. This is the first published study to identify modal parameters of a complex four-stage centrifugal compressor using Operational Modal Analysis (OMA). Vibrational response was measured contin
Lat. Am. j. solids struct.. Publicado em: 03/05/2018
-
8. Updating Finite Element Model Using Stochastic Subspace Identification Method and Bees Optimization Algorithm
Abstract This study investigates the application of operational modal analysis along with bees optimization algorithm for updating the finite element model of structures. Bees algorithm applies instinctive behavior of honeybees as they look for nectar of flowers. The parameters that needed to be updated are uncertain parameters such as geometry and material
Lat. Am. j. solids struct.. Publicado em: 26/04/2018
-
9. Numerical Study of Vibro-Acoustic Responses of Un-Baffled Multi-Layered Composite Structure under Various End Conditions and Experimental Validation
Abstract This article presents the vibro-acoustic modeling and analysis of un-baffled laminated composite flat panels subjected to harmonic point load under various support conditions. The frequency values of the panel are obtained by using simulation model through the commercial finite element package (ANSYS) via batch input technique. Initially, the rate o
Lat. Am. j. solids struct.. Publicado em: 2017-08
-
10. Parametric Modal Study and Optimization of the Floor Pan of a B-Segment Automotive Using a Hybrid Method of Taguchi and a Newly Developed MCDM Model
Abstract The floor pan is an important component that connects the front and rear segments of the automotive underbody structure. Global stiffness and NVH characteristics of BIW are highly dependent to shape, thickness and mass of the body panels and could be evaluated by modal characteristics of these panels. The feeling of solidness and comfort of passenge
Lat. Am. j. solids struct.. Publicado em: 2016-12
-
11. Crack Detection Using Mixed Axial and Bending Natural Frequencies in Metallic Euler-Bernoulli Beam
Abstract For many years, several crack detection attempts have been using measurements of the structure's modal parameters. One of the easiest is to measure and correlate the change in natural frequencies to cracks. The direct and inverse problem have been discussed in literature. However, the inverse problem, being addressed in this paper, is a challenging
Lat. Am. j. solids struct.. Publicado em: 2016-09
-
12. Comparison of In-Flight Measured and Computed Aeroelastic Damping: Modal Identification Procedures and Modeling Approaches
ABSTRACT The Operational Modal Analysis technique is a methodology very often applied for the identification of dynamic systems when the input signal is unknown. The applied methodology is based on a technique to estimate the Frequency Response Functions and extract the modal parameters using only the structural dynamic response data, without assuming the kn
J. Aerosp. Technol. Manag.. Publicado em: 2016-06