Short Circuit Current
Mostrando 1-12 de 273 artigos, teses e dissertações.
-
1. Short Circuit and Recovery Time Tests in a helical bifilar R-SFCL module
Abstract Superconducting Fault Current Limiter (SFCL) modules with distinct arrangements have been investigated, seeking design and performance enhancements. In this context, this work aims to propose a design for resistive SFCL (R-SFCL) modules, using RE-Ba-Cu-O high-temperature superconducting tapes (HTS) wound on an alternative support material. An R-SFCL
J. Microw. Optoelectron. Electromagn. Appl.. Publicado em: 2021-06
-
2. Effect of Push-Pull Ruthenium Complex Adsorption Conformation on the Performance of Dye Sensitized Solar Cells
A new series of tris-(bipyridyl)ruthenium-like complexes based on the 4-tripheylamine-2,2’:6’,2’’-terpyridine (TPA) push-pull ligand was prepared by incorporation of 4-carboxypyridine (cpy), 4,4’-dicarboxi-2,2’-bipyridine (dcbpy) and 4-carboxyterpyridine ligands (ctpy) ligands, in order to adsorb them on TiO2 in different anchoring conformations.
J. Braz. Chem. Soc.. Publicado em: 2020-11
-
3. Flexible, Large-Area Organic Solar Cells With Improved Performance Through Incorporation of CoFe2O4 Nanoparticles in the Active Layer
Cobalt ferrite (CoFe2O4) nanoparticles (NPs), with an average diameter of about 4-10 nm, were produced by the proteic sol-gel method and successfully doped into the active layer of poly(3-hexylthiophene-2,5-diyl) (P3HT):[6,6]-phenyl-C61-butyric acid methyl ester (PCBM) organic solar cells. Pristine and CoFe2O4 NPs-doped blends of P3HT:PCBM were dispersed in
Mat. Res.. Publicado em: 13/01/2020
-
4. Photoelectrodes with titanate nanotubes sensitized by mesoporphyrin derivative from cashew nut shell
ABSTRACT Titanate nanotubes (TiNTs) with the chemical composition Na2Ti3O7.nH2O (NaTiNT) were obtained through a hydrothermal method in highly alkaline medium. Protonated titanates nanotubes (H-TiNTs), with the composition H2Ti3O7.nH2O, were prepared by ion exchange reaction through a suspension of Na2Ti3OγnH2O nanotubes in HCl medium, promoting the exchang
Matéria (Rio J.). Publicado em: 20/05/2019
-
5. Uma Metodologia para Análise da Distribuição de Contagem dos Picos de Tensão de Reignição para Avaliação da Estabilidade do Processo GMAW Curto-Circuito
Resumo A estabilidade do arco tem sido estudada através de análises estatísticas obtidas dos sinais de tensão de arco e corrente de soldagem. Histogramas e cálculo de estatísticas dos parâmetros tempo de arco aberto e tempo de curto circuito são meios de avaliação da estabilidade dos processos de soldagem. Contudo, estudos relacionados aos picos de
Soldag. insp.. Publicado em: 09/05/2019
-
6. Performance Evaluation of Titanate Nanotubes and Nanoribbons Deposited by Electrophoresis in Photoelectrodes of Dye-Sensitized Solar Cells
Nanoparticles of TiO2 have been the main semiconductor applied in Dye-sensitized solar cells (DSSCs). In this work, titanate nanotubes (NaTiNT) and nanoribbons, were obtained by the hydrothermal method from TiO2 anatase. These materials were deposited on conductive substrate by electrophoresis, with and without thermal treatment, sensitized by ruthenium-base
Mat. Res.. Publicado em: 28/05/2018
-
7. Theoretical study of c-GaN/GaAs single heterojunction solar cells
ABSTRACT In this work a theoretical study of electrical behavior for a c-GaN/GaAs heterostructure as a photovoltaic device through a two-dimensional (2D) finite element numerical simulation is presented for a first time. I-V curves and electrical parameters like short circuit current (Isc), open circuit voltage (Voc), fill factor (FF) and efficiency (η) wer
Matéria (Rio J.). Publicado em: 02/10/2017
-
8. Construction and measurement of an electromagnetic noise generator based on an automotive coil
This article covers the design of an electromagnetic noise generator which uses an automotive coil as the main component. A short theoretical analysis covers the generation of high voltage pulsed current from the available DC source originated from the battery. An electronic dimmer, a circuit used to control the brightness of a light, by controlling the effe
Rev. Bras. Ensino Fís.. Publicado em: 22/06/2017
-
9. Impact of acute undernutrition on growth, ileal morphology and nutrient transport in a murine model
Undernutrition represents a major public health challenge for middle- and low-income countries. This study aimed to evaluate whether a multideficient Northeast Brazil regional basic diet (RBD) induces acute morphological and functional changes in the ileum of mice. Swiss mice (∼25 g) were allocated into two groups: i) control mice were fed a standard diet
Braz J Med Biol Res. Publicado em: 10/10/2016
-
10. Evenmatched FCAW process in API 5L X80 steel welded joint
The evenmatched welding conditions in FCAW-G process were used in API 5L X80 steel. In this study, two joint geometries (bevel 25° and 35°) with different process parameters were used. Each type of joint was welded with one type of consumable: AWS E81T1-Ni1C (evenmatched), with variation of heat input. During welding the voltage and current varied in a ran
Mat. Res.. Publicado em: 24/01/2014
-
11. Análise de filmes antirreflexo de dióxido de titânio e nitreto de silício em células solares P+NN+
In this work we compared the antireflection coatings of titanium dioxide and silicon nitride for p+nn+ solar cell fabrication. This type of solar cell is more stable in the long term compared to n+pp+ cells and allows obtaining higher efficiencies. TiO2 films were produced by evaporation in high vacuum by electron beam and by chemical vapor deposition at atm
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 07/12/2012
-
12. Otimização e comparação de processos para formação do campo retrodifusor com boro em células solares
The aim of this thesis was to develop and compare methods for the formation of the back surface field and emitter with boron using n-type and p-type solar-grade Si-Cz wafers as well as analyze and optimize a manufacturing process of solar cells with structure n+pp+ and back surface field formed by boron. The highly doped p+ region was formed by spin-on depos
IBICT - Instituto Brasileiro de Informação em Ciência e Tecnologia. Publicado em: 27/03/2012