Temperature Variation
Mostrando 1-12 de 972 artigos, teses e dissertações.
-
1. Tailoring the properties of Y2O3 via synthesis parameters varied during the PVA-assisted sol-gel route
Abstract The effect of synthesis parameters on the microstructural behavior and morphology during the yttrium oxide (Y2O3) formation is reported. Y2O3 crystals were produced by a modified sol-gel route assisted by polyvinyl alcohol solution varying the calcination temperature and solution pH. The crystalline phase formation was investigated using X-ray powde
Cerâmica. Publicado em: 2023
-
2. Effect of sintering temperature on mechanical and bioactivity properties of bioactive glass and cordierite composite
Abstract In this study, a composite of bioactive glass (BG) and cordierite (BG-cord) was proposed to increase the strength and bioactivity of BG. Both BG and cordierite were separately synthesized with the method of glass melting, then, they were used to fabricate BG-cord with a variation of sintering temperature (600 to 1000 °C). The highest diametral tens
Cerâmica. Publicado em: 2022
-
3. Thermal Infrared Enthalpimetry Method for the Determination of Hypochlorite in Bleaching Solutions
Thermal infrared enthalpimetry (TIE) was used for hypochlorite determination in commercial hypochlorite-based bleaching solutions. Experimental parameters were evaluated for the reaction with a hydrogen peroxide solution. The most relevant conditions were 5% H2O2 (m/m) solution, stirring speed of 250 rpm, dispensing rate of 0.57 mL s-1, and 10 s after reacti
Journal of the Brazilian Chemical Society. Publicado em: 2022
-
4. X-ray line profile analysis and magnetic and optical properties of FexZn0.95-xCr0.05O nanoparticles fabricated by sol-gel route
Abstract FexZn0.95-xCr0.05O nanoparticles have been obtained for the different concentrations of Fe ions by using the sol-gel method. The hexagonal wurtzite structure of all the samples was confirmed by Rietveld refined X-ray diffraction patterns. The addition of Fe ions decreased lattice constants a and c from 3.2487 to 3.2474 Å and 5.2043 to 5.2029 Å, re
Cerâmica. Publicado em: 2022
-
5. Sintering mechanisms of partially stabilized zirconia (TZ3Y) with ZnO and Co3O4 as sintering additives
Abstract In this work, the sintering mechanisms of 3 mol% yttria-stabilized zirconia (TZ3Y) and TZ3Y containing 0.3 wt% of ZnO or Co3O4 were analyzed by determining the apparent activation energy of sintering from dilatometry data and observing the evolution of microstructure. Dilatometry test was performed at a heating rate ranging from 5 to 20 °C/min from
Cerâmica. Publicado em: 2021-06
-
6. EVALUATING HOW THE TEMPERATURE CHANGES IN A SUNKEN SOLAR GREENHOUSE
ABSTRACT An increasing amount of sunlight is available to sunken greenhouses located in northern China, but it remains unclear how the indoor temperature changes at different heights and at the north and south ends of the structure. To study how the temperature in a single indoor section, at multiple points, varies in a sunken solar greenhouse, 10 measuremen
Eng. Agríc.. Publicado em: 2021-05
-
7. Addressing interpersonal conflict among healthcare workers during the coronavirus pandemic
ABSTRACT The environment control of broiler houses must be done adequately to provide good thermal conditions to broilers without wasting energy. The objective of this study was to characterize the thermal environment in two mechanically ventilated broiler houses with a negative pressure ventilation system, one with a cellulose pad evaporative cooling system
Braz. J. Psychiatry. Publicado em: 2020-10
-
8. CHARACTERIZATION OF THE THERMAL ENVIRONMENT IN BROILER HOUSES WITH DIFFERENT CLIMATE CONTROL SYSTEMS
ABSTRACT The environment control of broiler houses must be done adequately to provide good thermal conditions to broilers without wasting energy. The objective of this study was to characterize the thermal environment in two mechanically ventilated broiler houses with a negative pressure ventilation system, one with a cellulose pad evaporative cooling system
Eng. Agríc.. Publicado em: 2020-10
-
9. Catalytic Dehydration of Glycerol to Acrolein over Aluminum Phosphate Catalysts
Gas phase conversion of glycerol to acrolein over a variety of aluminum phosphate (AlP) catalysts synthesized by a simple replacement reaction method with a variation in calcination temperature (300-700 ºC, AlP-300, AlP-400, AlP-500, AlP-600, and AlP-700, respectively) has been investigated. The textural properties, acidities and coke contents of the sample
J. Braz. Chem. Soc.. Publicado em: 2020-08
-
10. BEHAVIOR OF BROILERS UNDER THE INFLUENCE OF LED LIGHTING AND MICROMETEOROLOGICAL ELEMENTS
ABSTRACT The objective of this research was to analyze the differences between the food behaviors observed under the factors of production environment, sex and lighting system, using stochastic tools of multivariate analysis. As for the thermal characteristics of the environment, air temperature (T, °C), enthalpy (H, kJ kg-1), and black globe temperature an
Eng. Agríc.. Publicado em: 2020-06
-
11. Does an urban environment affect leaf structure of Eugenia uniflora L. (Myrtaceae)?
ABSTRACT External factors can interfere with the structure and biological activity of plants. Nevertheless, the susceptibility of plants to specific environmental conditions varies, which raises many questions about the behavior of medicinal plants when grown in urban areas. This study aims to detect possible changes induced by exposure of Eugenia uniflora L
Acta Bot. Bras.. Publicado em: 2020-06
-
12. EFFECTS OF SEASONAL AIR TEMPERATURES AND LIGHT ON LEAF TRAITS AT ATLANTIC MONTANE FOREST, BRAZILIAN SOUTHEAST
ABSTRACT Seasonal variation of temperature could place physiological constraints on the distribution and performance of tropical forest plants, associated with light and water availability. A simple way to assess the relationship between temperature and plant physiology is through the characterization of leaf traits. The main aim of this study was to evaluat
CERNE. Publicado em: 20/12/2019