Ternary Systems
Mostrando 1-12 de 94 artigos, teses e dissertações.
-
1. Ternary system Portland cement-calcium aluminate cement-calcium sulfate applied to self-leveling mortar: a literature review
Abstract The modernization of building systems is increasingly demanding products that improve efficiency during their processing. The development of self-leveling mortars for the regularization of flooring is a consequence of this evolution. The high contents of binder and water to obtain self-flowing property, plus the application of thin layers over large
Cerâmica. Publicado em: 2021-03
-
2. Inclusion complexes and self-assembled cyclodextrin aggregates for increasing the solubility of benzimidazoles
Albendazole and fenbendazole are imidazole derivatives that exhibit broad spectrum activity against parasites, but the low solubility of these drugs considerably reduces their effectiveness. Complexation of albendazole and fenbendazole with cyclodextrins (β-cyclodextrin and hydroxypropyl-β-cyclodextrin) in both water and an aqueous solution of polyvinylpyr
Braz. J. Pharm. Sci.. Publicado em: 25/11/2019
-
3. Experimental and Computational Studies of the Adsorption of Furan, Pyrrole, and Thiophene on Hydroxyapatites in a Single and Ternary Component
Non-doped (Hap) and doped hydroxyapatites with Cu2+ and Fe2+ were synthesized and used to study the adsorption of furan (Fur), pyrrole (Pyr), and thiophene (Thi) in single and ternary component systems. Spectroscopic data and N2 isotherms indicated there were no structural alterations in Hap with the incorporation of Cu2+ and Fe2+. For both single and ternar
J. Braz. Chem. Soc.. Publicado em: 24/10/2019
-
4. Development of self-nanoemulsifying tablet (SNET) for bioavailability enhancement of sertraline
Abstract The purpose of the study was to combine the advantages of self-nanoemulsifying drug delivery systems and tablets as a conventional dosage form. Self-nanoemulsifying drug delivery system (SNEDDS) was prepared to enhance the solubility and thus oral bioavailability of sertraline. Aqueous titration method was used to prepare the liquid SNEDDS; ternary
Braz. J. Pharm. Sci.. Publicado em: 07/06/2018
-
5. Experimental Evaluation of 300 ºC section of Cu-In-Ni Phase Diagram, Hardness and Electrical Conductivity of Selected Alloy
The paper reports comparative experimental and thermodynamic calculation of a Cu-In-Ni ternary system. An isothermal section of the Cu-In-Ni system at 300 ºC was extrapolated using optimized thermodynamic parameters for the constitutive binary systems from literature. Microstructural and phase composition analysis were carried out using scanning electron mi
Mat. Res.. Publicado em: 03/05/2018
-
6. Activity and Stability of Dispersed Multi Metallic Pt-based Catalysts for CO Tolerance in Proton Exchange Membrane Fuel Cell Anodes
ABSTRACT Studies aiming at improving the activity and stability of dispersed W and Mo containing Pt catalysts for the CO tolerance in proton exchange membrane fuel cell (PEMFC) anodes are revised for the following catalyst systems: (1) a carbon supported PtMo electrocatalyst submitted to heat treatments; (2) Pt and PtMo nanoparticles deposited on carbon-supp
An. Acad. Bras. Ciênc.. Publicado em: 16/04/2018
-
7. Morphology and Phase Formation During the Solidification of Al-Cu-Si and Al-Ag-Cu Ternary Eutectic Systems
The microstructure of ternary alloys in the Al rich corner of the Al-Cu-Si and Al-Ag-Cu systems were analyzed in order to determine the solidification path in the different structural regions expected from the equilibrium phase diagram. The analysis was based on theoretical models developed in the literature for solidification of ternary eutectic system allo
Mat. Res.. Publicado em: 26/02/2018
-
8. Ethylene glycol oxidation on ternary PtRhNi/C electrocatalyst with different metal compositions
ABSTRACT Direct Alcohol Fuel Cells (DAFC’s) are an alternative to fuel cell systems and when is used alkaline medium this has an increase performance. The alkaline direct alcohol fuel cells (ADAFC's) have some advantages such as low-emission, high energy efficiency, improved oxidation kinetics, low crossover and in addition there is a broad range of materi
Matéria (Rio J.). Publicado em: 20/07/2017
-
9. An Efficient Human Identification through MultiModal Biometric System
ABSTRACT Human identification is essential for proper functioning of society. Human identification through multimodal biometrics is becoming an emerging trend, and one of the reasons is to improve recognition accuracy. Unimodal biometric systems are affected by various problemssuch as noisy sensor data,non-universality, lack of individuality, lack of invaria
Braz. arch. biol. technol.. Publicado em: 23/01/2017
-
10. Green tea glycolic extract-loaded liquid crystal systems: development, characterization and microbiological control
ABSTRACT Liquid crystal systems (LCSs) have interesting cosmetic applications because of their ability to increase the therapeutic efficiency and solubility of active ingredients. The aim of the present research was to develop green tea glycolic extract-loaded LCSs, to characterize and to perform microbiological control. The ternary phase diagram was constru
Braz. J. Pharm. Sci.. Publicado em: 2016-09
-
11. Evaluation and enhancement of heavy metals bioremediation in aqueous solutions by Nocardiopsis sp. MORSY1948, and Nocardia sp. MORSY2014
ABSTRACT An analysis of wastewater samples collected from different industrial regions of Egypt demonstrated dangerously high levels of nickel (0.27-31.50 mg L-1), chromium (1.50-7.41 mg L-1) and zinc (1.91-9.74 mg L-1) in the effluents. Alarmingly, these heavy metals are among the most toxic knownones to humans and wildlife. Sixty-nine Actinomycete isolates
Braz. J. Microbiol.. Publicado em: 2016-09
-
12. Composition, Elastic Property and Packing Efficiency Predictions for Bulk Metallic Glasses in Binary, Ternary and Quaternary Systems
The results of database based on the efficiency packed model for metallic glasses. The database contains the atomic radii information as well as elastic properties of the most commonly used alloying elements, permitting composition, packing efficiency and elastic property predictions to be made for binary, ternary and quaternary bulk metallic glasses. Twenty
Mat. Res.. Publicado em: 08/03/2016